ndt

“Since 1952 the best products and instruments for non destructive testing”

GAS LEAK DETECTION


NDT Italiana GAS PROOF FOR BUBBLE TEST

GAS PROOF FOR BUBBLE TEST

GAS PROOF - Paste is a high concentrated paste, which is delivered in spray cans ready for use and 1 kg plastic container to be diluted with water before use at dilution ratio of 1 to 400.
Gas proof is made of pure synthetic surface active agents without oil, fat, fat acids and all soap solids. Because of this GAS PROOF is not inflammable, not toxic and suited for all technical gases inclusive pneumatic. GAS PROOF is approved for the use in oxygen installations. So there is no close up of hairline cracks by soap solids.
GAS PROOF - Paste can be used in high-, middle- and low-pressure range. It is suitable for all gas- and pneumatic-installations, for machinery as well as tank constructions.

14.100 GP1KG - GAS PROOF CONCENTRATED 1 KG to be diluted in 200 to 400 liters of water

14.111 GPKSP - GAS PROOF SPRAY 400 ml

 


NDT Italiana VACUUM BOX SET WITH VACUUM PUMP 

14.120 SVBP VACUUM BOX SET WITH VACUUM PUMP

Vacuum box kit is necessary when it is not possible to obtain a differential pressure on opposite side where you apply your leak test bubbles liquid. Our transparent vacuum box, stick to the area to be checked, by vacuum obtained by a pump to discover possible leaking.

14.140 VB1 FLAT WELDINGS BOX

Made by transparent reinforced plastic. Complete of sealing gasket, connector to vacuum pipe, calibrated vacuum meter.
Dimensions: cm 50x10x7 (Specials on request)

14.150 VB2 90° ANGLE WELDINGS BOX

Made by transparent reinforced plastics. Complete of sealing gasket, connector to vacuum pipe, calibrated vacuum meter.
Dimensions: cm 35x10x7 (Specials on request)

14.130 SVBE VACUUM BOX SET WITH AIR EJECTOR (no electricity required)

Vacuum box kit is necessary when it is not possible to obtain a differential pressure on opposite side where you apply your leak test bubbles liquid. Our transparent vacuum box, stick to the area to be checked, by vacuum obtained by ejector to discover possible leaking.